10. After the equipment is started, immediately check whether the belt swing is within the required range and whether there are other abnormal phenomena, otherwise, it should be adjusted or shut down immediately.
11. It is strictly forbidden to start the wire drawing machine and the dust collecting fan at the same time, and it is strictly forbidden for the operator to leave the work post after starting.
12. It is strictly forbidden that the workpiece is directly placed on the conveyor belt without a pallet for filament drawing, and the wooden pallet is strictly prohibited from being placed on the workpiece for wire drawing without a stop bar, so as to avoid damage to the conveyor belt and the workpiece flying out and hurting people.
13. When working with two people, the operator behind the equipment must not face the exit of the wire drawing machine, so as to prevent the workpiece from flying out and hurting people.
14. The pressure adjustment of the plastic filament extruding machine should be moderate. Under normal circumstances, the pressure gauge indication should be between 35 and 75. It is strictly forbidden to exceed the red line to avoid equipment or personal accidents.
15. It is strictly forbidden to adjust the air pressure when the equipment is in normal operation, so as to avoid the loss of control of the sanding belt and cause equipment and personal accidents.
16. If abnormal phenomena occur during the operation of the equipment, it should be shut down or power off immediately to avoid the expansion of the fault.
17. When the equipment is overhauled, the main power supply should be turned off, and operation should be strictly prohibited with a sign to avoid accidents.
Post time: Dec-28-2021